Active Member

Wednesday Open Space Night at CT Hackerspace

Date: 
Wed, 12/05/2012 - 6:00pm

Wednesday Open Space Night at CT Hackerspace

OPEN TO THE PUBLIC NIGHT !

Wednesday, December 5, 2012
6:00 PM

CT Hackerspace
30 Echo Lake Road, 3rd floor, Watertown, CT (map)

When you reach our address, follow Silk Street around the back of the building. Rear Main Entrance is at the top of the ramp

CT Hackerspace at 30 Echo Lake Road, 3rd floor Watertown, CT. GPS will get you to the address, then follow Silk Street around to the back of building.

Login Types: 
Access: 

CNC Engraver/Mini Mill

 I think I am now at the point wher I can deem the Mini CNC Mill/Engraver operational again.  We had the machine functioning well imediately after the build was complete using a borrowed control set-up but that stepper driver set has since gone back to its owner. In the time sense, I have been working on a "universal" stepper driver/parallel port break out board set up that could be use for this machine. I have had a few issues to troubleshoot but I feel as though I can now say that my "universal' stepper driver/break out board is functional with this machine. 

Login Types: 
Access: 

Flash Event: CNC Mill Conversion Sunday OPEN TO THE PUBLIC

Date: 
Sun, 12/11/2011 - 10:00am to 2:00pm

I'm in the process of converting my Taig manual mill into a 3 axis CNC mill.  Right now I need to finish the driver control box and setup a PC to run EMC2.  Feel free to stop by and check it out.  OPEN TO THE PUBLIC

Access: 

Making Chips

Making Chips

 Making Chips on the Lathe

Login Types: 
Access: 
Subscribe to RSS - Active Member